Thursday, December 10, 2015

Speed Strip Carrier

In my previous post I detailed how I made a magazine carrier from Kydex.  My next project was a carrier for a Bianchi Speed Strip for a revolver.  The process is essentially the same as outlined in the prior posting.  If you read the prior post and look at these pictures, you can figure it out.  This is designed to go in the right front pocket.  The preferred method for loading a revolver regardless of which hand you shoot with is to hold the gun in your left hand and load it with your right.  If you pocket carry in your right front pocket, you can put this in your left front pocket, but reloading might be awkward.



Front view.


Back view with Speed Strip.



Back view with Speed Strip inside carrier.  The back flap is bent inward a bit to apply a little pressure to the Speed Strip to keep it from rattling.



In the pocket.

No comments:

Post a Comment